Reposition your instant center by changing your lower control arm angle for improved traction. Brackets lower the rear of the control arm up to 3", a must for all lowered vehicles to correct lost suspension geometry. By lowering your vehicle, you are changing the lower control arm angle allowing the rear mounting point to sit higher than the front. This will, in return, cause wheel hop and a great deal of traction loss. Relocation brackets have two settings to allow the lower control arm to be lowered either 2" or 3", depending on your preference. Settings are placed in a correct pattern that will allow use of all OEM control arms or any aftermarket control arm (brackets do not require a longer control arm.) Brackets installed on a non-lowered F-Body provide a .10 or better 60-foot; reduction and an increase in track consistency.

Installation:
Brackets are Weld-in only and install in approximately 1 - 1� hours. All hardware and installation instructions are included with each kit.

Available for the following vehicles:
• Chevrolet Camaro & Pontiac Firebird, 1982-1992
• Chevrolet Camaro & Pontiac Firebird, 1993-1997
• Chevrolet Camaro & Pontiac Firebird, 1998-2002